Setup Bottango Solar

In this final step, we’ll get the new pro circuit board (Bottango Solar) attached and get all the cables in the right place.

Parts Needed:

• Bottango Solar
• M3 short nylon bolts
• Philips head screwdriver (provide your own)
• speaker cable labels

Remove Servo 1 from the Cable Bundle

We’re going to reroute the servo cable bundle, but first we need to remove the number 1 servo cord from the cable bundle. You should have added the number 1 servo into the bundle at the last “hook and loop” cable tie. Temporarily undo that tie, just enough to remove the number 1 servo cord from the bundle, then retighten it. If you have the number one servo cable in other ties, remove it from those as well.

Unroute the cable bundle so it is free and clear, off to the left hand side (Captain Cogbrow’s left) of the back plate.

Add cable labels to the speaker cables

We’re going to add the speaker cables to the bundle of servo cables, but we’ll need to remember which one is which. We’ll mark them with numbers not used by the servos (1 - 7).

Take the left side speaker cable (Captain Cogbrow’s left), and add the cable marker “0”. Take the right side speaker cable (Captain Cogbrow’s right), and add the cable marker “8”.

Add the Speaker Cables to the Bundle

Undo the “hook and loop” cable ties, one by one, add the speaker cable in, and then re-tighten. Only add the speaker cables to the “hook and loop” cable ties from the bundle after it exits the back of the wheel, you don’t need to route the speaker cables back to the head and then out again.

Route the Bundle

Route the bundle of wires up into the back brace, between the left side standoffs and the left side speaker (Captain Cogbrow’s left).

Then back down agian through the other side, between the right side standoffs and the right side speaker.

Here’s the end result routing:

Add Servo 1 Back Into the Bundle

Untie the furthest out “hook and loop” cable tie, and add the number 1 servo cable back into the bundle, then retighten. You should now have 9 cables in the bundle:

• Servos 1 - 7
• Left Speaker
• Right Speaker

Mount Bottango Solar

Use three small nylon bolts to mount Bottango solar directly to the bottom nylon standoffs, where the previous plastic board mounting plate was needed. Bottango solar itself has the same mounting pattern as that plastic plate. Don’t overtighten and damage the board, you just want it secured enough that it won’t fall off.

The mounting holes will only line up in the correct orientation shown:

Plug In Servos

One by one, for all 7 servos, plug them into the correct servo header, in the correct orientation.

Remember the color guide, and follow the guide on the Bottango Solar board:

• S is Yellow
• + is Red
• - is Brown

Though this step isn’t hard to do, it’s also easy to make a mistake. For each servo:

• Make sure the right servo is in the right header. Use the cable clip labels to determine which servo is which.
• Make sure you have the three prongs of the header lined up with the three holes of the extension
• Make sure the extension is fully seated on the board
• Triple check you have the cable oriented the right way, with S + and - all in the right spot.

Plug In Speakers

Plug the left speaker cable (with the “0” clip label) into the speaker port with the “L” symbol. The black cord is on the “-” side and the red cord is on the “+” side

Repeat with the right speaker cable in the “R” port.

The speaker hookups will only go in if oriented correctly. If you ever need to remove a speaker once hooked in, pull up from the plastic jack on the cable, not the cable iself.

Next Up

In the final short section, we’ll double check a few things and make sure everything is wired up correctly.